Epson GX Series Manual page 188

Industrial Robot: SCARA Robots GX series Manual
"Protected-Model"
The following procedure should be followed when transporting the Manipulator by hoisting.
1. Attach the eyebolts to the top of the Manipulator base.
2. Place the Manipulator arm in the extended position.
3. Ensure that the hoisting belt can be secured to Arm #2. Using the metal part of the shaded area as a guide, apply the band
so that it does not shift.
POINTS
✏
Please note that the plastic cover section may be damaged if a load is applied to it.
4. To prevent the Manipulator from falling over, lift while providing support at the position indicated by the arrow, and move
it to the base table where it will installed.
Symbol Description
a Hoisting belt
b M8 eyebolts (included)
a
b
Rev.7
188