Connecting The Cables - Epson GX Series Manual

Industrial Robot: SCARA Robots GX series Manual

2.3.5 Connecting the Cables

WARNING
To perform the power supply lockout, remove the power plug. Be sure to connect the AC power cable to a
power outlet. Do not connect it directly to a factory power source.
Before performing any replacement work, inform others in the area that you are working, and then turn off the
Controller and related equipment, and unplug the power cable from the power source. Performing any work
procedure with the power turned on is extremely dangerous and may result in electric shock and/or
malfunction of the robot system.
Be sure to connect the cables properly. Do not put heavy objects on the cables, bend or pull on the cables
forcibly, or allow the cables to be pinched. Damaged cables, broken wires, or contact failure is extremely
hazardous and may result in electric shock and/or malfunction of the robot system.
The Manipulator is grounded by connecting it to the Controller. Ensure that the Controller is grounded and the
cables are correctly connected. If the ground wire is improperly connected to ground, it may result in the fire
or electric shock.
CAUTION
When connecting the Manipulator and the Controller, check that the serial numbers match for each device.
Improper connection between the Manipulator and the Controller may not only lead to malfunction of the robot
system but also serious safety problems. The connection method between the Manipulator and the Controller
varies depending on the Controller. For details on the connections, refer to the following manual.
"Controller Manual"
When the Manipulator is a model with cleanroom & ESD specifications, please note the following points.
When the Manipulator is a model with cleanroom & ESD specifications, an exhaust system must be connected. The exhaust
system is described in the following section.
Appendix A: Specifications Table
Connection procedure for Manipulator and M/C cable
Insert the M/C cable hood into the M/C cable housing on the back and bottom of the Manipulator, and secure it with the lock
attached to the housing.
1. Open the lock plates on both sides of the M/C cable housing.
2. Insert the M/C cable hood all the way to the back.
3. Close the lock plates on both sides of the M/C cable housing.
1 2 3
Rev.7
69