Table of Contents
Advertisement
Industrial Robot: SCARA Robots GX series Manual
3.3.7.2 Table Top Mounting Specifications
CAUTION
Be sure to use four or more people when installing or relocating a model with table top mounting
specifications, and use three or more people when lifting a Manipulator. The Manipulator weights are as
follows. Be careful not to get hands or feet caught or have equipment damaged due to dropping of the
Manipulator.
GX8-A45***, GX8-B45***: Approx.33 kg (73 lbs)
GX8-A55***, GX8-B55***: Approx.34 kg (75 lbs)
GX8-A65***, GX8-B65***: Approx.35 kg (77 lbs)
1. Turn off all power, and remove the wiring and tubes connected to the Manipulator.
POINTS
✏
If using variable mechanical stops for Joints #1 and #2 and the operating angle is limited, change to the
mechanical stop positions at factory shipping.
Setting the Work Envelope by Mechanical Stops
2. Wrap a sheet around the arm so that it will not get damaged.
Bind the lower end of the shaft to the arm and the base to the arm. Secure the arm while referring to the figure below.
a
b
c
d
Illustration: GX8-A552S
f
e
Rev.7
205
Advertisement
Table of Contents
