Epson GX Series Manual page 8

Industrial Robot: SCARA Robots GX series Manual
4.3.7 Relocation and Storage
4.3.7.1 Safety Information for Relocation and Storage
4.3.7.2 Table Top Mounting Specifications
4.3.7.3 Wall Mounting Specifications
4.3.7.4 Ceiling Mounting Specifications
4.4 Setting the Hand
4.4.1 Installing the Hand
4.4.2 Attaching Cameras and Valves
4.4.3 Weight and Inertia Settings
4.4.3.1 Weight Setting
4.4.3.1.1 Weight of Load Attached to Shaft
4.4.3.1.2 Weight of Load Attached to Arm
4.4.3.1.3 Automatic Speed Correction at Weight Setting
4.4.3.1.4 Automatic Acceleration/Deceleration Correction at Weight Setting
4.4.3.2 Inertia Setting
4.4.3.2.1 Moment of Inertia and Inertia Setting
4.4.3.2.2 Moment of Inertia of Load Attached to Shaft
4.4.3.2.3 Automatic Acceleration/Deceleration Correction of Joint #4 at Inertia (Moment of Inertia)
Setting
4.4.3.2.4 Eccentricity and Inertia Setting
4.4.3.2.5 Eccentricity of Load Attached to Shaft
4.4.3.2.6 Automatic Acceleration/Deceleration Correction at Inertia (Eccentricity) Setting
4.4.3.2.7 Calculating the Moment of Inertia
4.4.4 Safety Information for Auto Acceleration of Joint #3
4.4.4.1 Automatic Acceleration/Deceleration Correction by Shaft Position
4.5 Work Envelope
4.5.1 Work Envelope Setting by Pulse Range
4.5.1.1 Joint #1 Maximum Pulse Range
4.5.1.2 Joint #2 Maximum Pulse Range
4.5.1.3 Joint #3 Maximum Pulse Range
4.5.1.4 Joint #4 Maximum Pulse Range
4.5.2 Setting the Work Envelope by Mechanical Stops
4.5.2.1 Setting the Mechanical Stops of Joints #1 and #2
4.5.2.2 Setting the Mechanical Stop of Joint #3
4.5.3 Setting the Rectangular Range in the XY Coordinate System of the Manipulator
Rev.7
314
314
315
317
320
323
323
325
327
327
327
327
329
329
330
330
330
331
331
332
332
332
334
334
335
335
336
336
338
339
340
341
346
352
8