NEC UNIVERGE SV8300 Command Manual page 108

COMMAND CODE TITLE:
08
BASIC SERVICE: 301-398
301 When system is reseted
311 Display last calling station number
Display calling station number when a calling station abandons
a call before the call is answered
313 An Incoming call via UCD station in Exclusive Hold/Remote
Hold
319 On a Tie Line outgoing call with answer signal, transferring/
holding the call before distant called station answers.
NOTE:
Effective only when CM35 Y=000 is 03 or 04 and
CM35 Y=004 is 02.
322 Answering method of Camp-On (Call Waiting Method)
324 Direct-In Termination-Outside
(In the case of no release signal on incoming trunk and both
answer and release signals on outgoing trunk)
[8300R2]
331 Sender Prepause for outgoing call via attendant
333 Mail box number sent to VMS when VMS is recalled after
transferring the call to an unanswered station
334 Call to a station with a Return Message Schedule Display, and
receives ringing
335 Station number and name display when incoming call begins
ringing in
BASIC SERVICES
BASIC SERVICE
0 Multiline Terminal MIC lamp ON
1 Multiline Terminal MIC lamp OFF
0 6 seconds
1 Until next call
0 Not available
1 Available
0 Not income
1 To income
0 Not available
1 Available
0 Same as Camp-On transfer-method
(Switch Hook Flash + Call Hold
access code/Answer key)
1 Alternating between two calls by
Switch Hook Flash/Answer key
0 After the outgoing trunk receives the
response, the tandem connection is
allowed
1 The tandem connection is restricted
when the incoming trunk is no resto-
ration signal
0 To provide
1 Not provided
0 To send
1 Not sent
0 Available (Ringing)
1 Not available (ROT connection)
0 Display when incoming call termi-
nates to the Prime Line
1 Display when incoming call termi-
RESET
nates to the Prime Line or My Line
3-52
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.8.1
91ch3001.fm
JULY/17/2009
CM08