NEC UNIVERGE SV8300 Command Manual page 39

The examples of data setting are described below.
(1) Example in the case that station number 300 is to be assigned to Physical Port No. 010101 and station
number 301 to Physical Port No. 010102 by CM10 Y=00.
STEP 1 Set CAT mode.
STEP 2 Press
STEP 3 Enter "1000" (Command Code).
STEP 4 Press
STEP 5 Enter "010101" (Physical Port No.).
STEP 6 Press
Enter "300" (Station Number).
STEP 7
STEP 8 Press
STEP 9 Press
STEP 10 Press
STEP 11 Enter "301" (Station Number).
STEP 12 Press
STEP 13 Press
STEP 14 Lift handset, then replace it.
NOTE 1:
When no data exists, "NONE" is displayed. And when data exists, that data is displayed.
NOTE 2: This operation is for confirming the data assignment. You can omit this step.
DE
Example of CAT Operation
ST .
DE .
DE .
EXE .
DE .
S .
EXE .
DE .
(Display)
CAT MODE
COMMAND =
COMMAND = 1000
1000 >
1000> 010101
1000> 010101: NONE−
1000> 010101: NONE−300
OK
1000> 010101: 300 −
1000> 010102: NONE
1000> 010102: NONE−301
OK
1000> 010102: 301
1-25
Chapter 1 HOW TO USE CAT
CAT OPERATION
NOTE 1
NOTE 2
NOTE 1
NOTE 2
NWA-033623-001 Rev.8.1
JULY/17/2009
91ch1001.fm