NEC UNIVERGE SV8300 Command Manual page 208

Hide thumbs Also See for UNIVERGE SV8300:

Table of Contents

COMMAND CODE TITLE:

This command is used to assign station numbers, Intercom numbers, Loop Line numbers and ICI/OPR

Line numbers (for Multiline Terminal Attendant Position) to Virtual Lines assigned on Multiline Termi-

Virtual Line station numbers must be different from station numbers assigned by CM10.

The Virtual Port No. has no relation to the Physical/Virtual Port No. used in CM10.

Therefore, any Virtual Port No. can be assigned to each Virtual Line station number.

The system can accommodate maximum 1000 Virtual Line stations.

The accommodatable number of Virtual Line stations are difference calculated by subtracting

number of accommodated Multiline Terminals from total number of ports (=2000).

The following station data can be assigned to the Virtual Line station numbers.

• Station Class-1 (CM12)

• Station Class-2 (CM13)

• Service Restriction Class (CM15)

• Call Pickup Group/Group Diversion Group (CM16)

• ACD/UCD Group (CM17)

• Station Hunting Group (CM18)

• Direct-in Termination in Day/Night Mode (CM30 Y=04, 05)

• Call Forwarding-Busy Line

• Call Forwarding-No Answer

• Call Forwarding-I'm here (-Destination)

• Call Pickup

• Call Back (In this setting, My Line number is called back.)

• Outgoing Trunk Queuing (Trunk Queuing-Outgoing) (In this setting, My Line number is called

The same condition as My Line is applied to calls from the virtual line station.

Billing of virtual line station is executed to its My Line number

VIRTUAL LINE NUMBER

NWA-033623-001 Rev.8.1

JUNE/15/2011