NEC UNIVERGE SV8300 Command Manual page 99

COMMAND CODE TITLE:
08
163 Step Call for an incoming call from a Tie Line
165 Replay timer for Attendant Delay Announcement
[8300R2]
168 When the Multiline Terminal station dials "#" during setting of
Station Speed Dialing
171 When the Multiline Terminal station dials "*" during setting of
Station Speed Dialing
172 Automatic Idle Return on Multiline Terminal
176 1000-Slot Memory Block number "02" for Station Speed Dial-
ing is used as the Memory Block for System Speed Dialing
177 Last Number Call (Last Number Redial for Single Line Tele-
phone)
179 Ringing cadence on Direct in Termination
[Other than North America]
Ringing cadence on Direct in Termination
[North America Only]
BASIC SERVICES
BASIC SERVICE
0 Not available
1 Available
0 Replay at an interval
1 Replay only once
0 "#" is set as paused data (1.5 seconds)
1 "#" is set as dialed digit
0 "*" is set as programmable pause by
CM41 Y=0>38
1 "*" is set as dialed digit
0 Not available
1 Available
0 Available
1 Not available
0 Available
1 Not available
0 As per CM35 Y=033
1 Special Ringing for Multiline Termi-
nal
As per CM04 Y=00>07 for Single
Line Telephone
0 As per CM35 Y=033
1 Special Ringing for Multiline Termi-
nal
0.25 seconds ON-0.125 seconds OFF
-0.25 seconds ON-0.125 seconds OFF
-0.25 seconds ON-2 seconds OFF
As per CM04 Y=00>07 for Single
Line Telephone
3-43
: Default
SETTING DATA
See CM41 Y=0>47
See CM20 Y=0-3: A068
See CM20 Y=0-3: A069
See CM08>397
Continued on next page
NWA-033623-001 Rev.8.1
91ch3001.fm
JUNE/15/2011
CM08