NEC UNIVERGE SV8300 Command Manual page 548

COMMAND CODE TITLE:
76
Y
No. MEANING
39 Multiline Termi-
nal Ringer Tone
Pattern for DID
incoming call
with no CLI
NOTE 1: This command is effective when CM76 Y=34, 36 is set to 0 or 2, and Multiline Terminal receives the
incoming call.
NOTE 2: For details of the Ringer Tone Pattern see
40 Kind of call
termination
indicator key/
lamp on Atten-
dant console for
DID incoming
call with no CLI
[8300R2]
NOTE:
The command is effective when CM76 Y=34, 36 is set to 0, and the destination of call forwarding is
Attendant console.
41 Mobility Access
function to each
DID number
DIGIT CONVERSION ON DID CALL
1ST DATA
DATA
000-999:
Number Conver-
sion Block No.
assigned by
CM76 Y=00/90
000-999:
Number Conver-
sion Block No.
assigned by
CM76 Y=00/90
000-999:
Number Conver-
sion Block No.
assigned by
CM76 Y=00/90
2ND DATA
MEANING
0 Ringer Tone Pattern 0
1 Ringer Tone Pattern 1
2 Ringer Tone Pattern 2
3 Ringer Tone Pattern 3
4 Ringer Tone Pattern 4
5 Ringer Tone Pattern 5
6 Ringer Tone Pattern 6
7 As per CM76 Y=23
CM65 Y=40.
0 C.O. Incoming Call 0
1 C.O. Incoming Call 1
6 C.O. Incoming Call 6
7 As per CM35 Y=015
0 To use Mobility Access Termination
1 To set Mobility Access mode
(Trunk Access Code 1)
2 To cancel Mobility Access mode
3 To set Mobility Access mode
(Trunk Access Code 2)
[8300R6]
4 To set Mobility Access mode
(Trunk Access Code 3)
[8300R6]
5 To set Mobility Access mode
(Trunk Access Code 4)
[8300R6]
7 Mobility Access function is not used
3-492
CM76
: Default
REMARKS
CM65 Y=40
CM76 Y=23,
34, 36
CM35
Y=015
CM76 Y=34,
36
CM15
Y=216
CM64 Y=10,
14-16
Continued on next page
NWA-033623-001 Rev.8.1
91ch3005.fm
JUNE/15/2011