NEC UNIVERGE SV8300 Command Manual page 356

COMMAND CODE TITLE:
35
Y
No. MEANING
076 Designation of Area Code
Development Pattern No. for
Toll Restriction
Analysis, and Maximum
Digit Analysis.
078 Number of digits to be
converted on DID for Devel-
opment Table 0
079 Terminal connection form
for ISDN Basic Rate
Interface
BLADE RESET
See PRECAUTION (2)
083 Trunk seizure sequence for
an outgoing call
086 Centrex trunk
087 Distinctive Ringing by
detecting the ringing signal
from main PBX or Centrex
089 Cyclic Redundancy check-
ing for DTI trunk
BLADE RESET
See PRECAUTION (2)
NOTE:
This command is not effective when the DTI (E1 2 Mbps) is used (CM05 Y=0: 47). In that case, set
CMAA Y=01.
TRUNK ROUTE DATA
DATA
00 Area Code Development Pattern No. 0
07 Area Code Development Pattern No. 7
15 Not used
0 Leading 2-4 digits
1 All digits of DID number are converted by
CM76
0 Point-to-Point
1 Point-to-Multipoint
NOTE:
0 As per CM08>078
1 By allotter
0 To provide
1 Not provided
0 To provide
1 Not provided
NOTE 1:
NOTE 2:
0 To provide
1 Not provided
SETTING DATA
MEANING
Set 0 for BRT blade.
When this function is utilized, be sure
to set Trunk Line Appearance as the
terminating method (set by CM30
Y=02, 03: 02).
Tone Ringer is selected by CM35
Y=034, lamp control is set by CM35
Y=032 respectively.
3-300
CM35
: Default
RELATED
COMMAND
CM8A
Y=4000-4007
CM85 Y=0-7
CM35
Y=012, 018
CM76
CM08>078
CMA7 Y=64
CM30
Y=02, 03
CM30 Y=18
Continued on next page
NWA-033623-001 Rev.8.1
91ch3003.fm
JUNE/15/2011