NEC UNIVERGE SV8300 Command Manual page 155

COMMAND CODE TITLE:
0B
Y
No. MEANING
0XX 0 : Maintenance Port
XX: Unit No. (01-50)
RESET
LAN DATA ASSIGNMENT
1ST DATA
DATA MEANING
129 IP Address for the trap
source
NOTE 1:
Only Unit No. 01 can be set by this data.
NOTE 2: This data cannot be entered by CAT when using 8300R1 software.
NOTE 3: When setting the IP address by this data, a period (.) must be entered
between the numbers (example: 255.255.255.254).
NOTE 4: The IP address assigned by this data is set to the Agent address in
"SNMP TRAP PDU", and the system sends the IP address to the IP
network. Wherever the system is located on the LAN, system adminis-
trator can manage it easily by setting of the convenient IP address.
140 IP Address for Stand by
CPU
[8300R4]
NOTE 1: Only Unit No. 01 can be set by this data.
NOTE 2: This data is not effective for Secondary Unit (Unit No. 02-50).
NOTE 3:
Reset both Active CPU and Stand by CPU after this data setting.
141 Unit number for
Secondary Unit
[8300R6]
NOTE 1: Only Unit No. 01 can be set by this data.
NOTE 2: Set this data when Failover mode is used.
2ND DATA
DATA
XXX.XX IP Address for the trap
...X source
(Maximum 15 digits)
XXX.XXX.XXX.XXX=
0.0.0.1-255.255.255.254
NONE No data
XXX.XX IP Address
...X (Maximum 15 digits)
XXX.XXX.XXX.XXX=
0.0.0.1-255.255.255.254
NONE 192.168.1.101
02 Unit No. 02
50 Unit No. 50
NONE Not set
3-99
: Default
RELATED
COMMAND
MEANING
CM0B
Y=000>90
Continued on next page
NWA-033623-001 Rev.8.1
JUNE/15/2011
CM0B
91ch3001.fm