NEC UNIVERGE SV8300 Command Manual page 60

COMMAND CODE TITLE:
00
DATA TABLE:
1ST DATA
DATA
1 System data memory all clear
02 SRAM area all clear
[8300R2]
NOTE: Be careful handling CM00>02. Because all stored data in a SRAM area is cleared when the SRAM
area memory clear is executed by this command. Usually, this command is used only when initially
starting the system, or accommodating additional Units, or replacing the CPU blade, or SRAM
data is corrupted by such as power discontinuity of SV8300 (because of the battery backup for
SRAM is effective for approximately one week, the SRAM data is corrupted when SV8300 has been
powered off for more than one week).
10 Billing memory clear (SRAM)
[8300R2]
NOTE: The charging data which are cleared by this command are as follows (there is no charge).
• Call charge printout/display for individual station
• Call charge printout/display for each tenant
• Call charge printout/display for all tenants (for previous month)
• Call charge printout/display for all tenants (for this month)
• Call charge printout/display for all stations
• Call charge printout for all tenants at the set date and time
• Call charge printout for all stations at the set date and time
11 SRAM area clear for VRS built-in CPU/Call
charge output to SMDR
[8300R3]
SYSTEM DATA MEMORY ALL CLEAR/SRAM
CLEAR
MEANING
2ND DATA
DATA
CCC Clear
CCC Clear
CCC Clear
CCC Clear
3-4
CM00
OFF LINE
MEANING
NWA-033623-001 Rev.8.1
91ch3001.fm
JUNE/15/2011