NEC UNIVERGE SV8300 Command Manual page 44

ERROR MESSAGE
WRONG
SEE CMxx YYYY
USE CMxxxx
TRK NOT ASSIGNED
WD ERROR
MEMORY FULL
NOTE:
Depends on the command entered, either one of two error messages is displayed.
Error Messages
MEANING OF MESSAGE
The data stored in the memory is
wrong. This message is displayed
when too many digits are entered.
For example, when assigning "123"
for a service access code when "12"
has been already used for another
service access code.
Double assigned error of the same
station number or trunk number.
The data is already assigned by
another command.
The designated trunk is not assigned. Assign the trunk by CM10.
Error exists in memory.
Memory allocation disabled when
using finite memory with plural com-
mands.
Clear the present data by entering
"CCC", or enter the correct data.
The station number or trunk number
intended is already assigned to first
data YYYY of CMxx. Confirm.
The command code and YY number
already assigned are displayed. Con-
firm.
Check the second data to register and
enter the correct data.
Check the number of data registered.
1-30
Chapter 1 HOW TO USE CAT
ERROR MESSAGES
ACTION
NWA-033623-001 Rev.8.1
91ch1001.fm