NEC UNIVERGE SV8300 Command Manual page 136

Hide thumbs Also See for UNIVERGE SV8300:
Table of Contents

Advertisement

COMMAND CODE TITLE:
08
BASIC SERVICE: 1000-1031
1000 Operation of Recall key when a station receives SPDT after
hooking
[8300R3]
1001 Transfer a trunk line placed in Consultation Hold by Recall Key
(Hold Transfer) on Trunk-Direct Appearance
[8300R3]
1004 DT700/SP350 RTP warning tone
[8300R4]
1006 When connection failure between SV8300 and DT700, the call
is disconnected or continued
[8300R4]
NOTE:
DT700 has Keeping Call function and can continue the call until the terminal goes on-hook even when
SV8300 is reset, as long as they are in station-to-station calling (peer-to-peer) within same system. For
the calls connected via VoIP, however, the voice is interrupted at system reset, and this situation will
continue until on-hook. To avoid this, it is recommended to set the Keeping Call function of DT700 to
ineffective in dual CPU system. When it is set to ineffective, the stations are forcibly reset after 3 minutes
elapsed from SV8300 reset.
1007 Hold tone select for Standard SIP station
[8300R3.5]
NOTE 1:
When External Hold Tone is assigned by CM48 Y=0/CM64 Y=1, External Hold Tone is set for Stan-
dard SIP station regardless of this data.
NOTE 2:
When using 8300R6 software or later, CM08>1007 is effective when CM13 Y=74 is set to 1.
1008 Tenant No. for calling from DESKCON
[8300R5]
NOTE:
If tenant No. for DESKCON (assigned by CM60 Y=35) is not assigned, tenant No. for calling from
DESKCON is set to the lowest tenant No. of station tenants for each ATT group (assigned by CM62)
when this data is set to "0".
BASIC SERVICES
BASIC SERVICE
0
Recall key is not available
1
Return to the original call
0
Available (Hold Transfer)
1
Not available (Recall)
0
Not sent
1
To send
0
To disconnect
1
To continue
0
Hold Tone Source on CPU blade
(selected by CM48)
1
Hold Tone Source on Standard SIP
station
0
Tenant No. for each DESKCON
(assigned by CM60 Y=35)
1
The lowest tenant No. of station
tenants for each ATT group
(assigned by CM62)
3-80
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.8.1
91ch3001.fm
JANUARY/31/2012
CM08

Advertisement

Table of Contents
loading

Table of Contents