[Cm10] Station Number, Trunk Number, Blade Number - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
10
FUNCTION:
This command is used to assign station numbers, trunk numbers, and blade numbers to Physical Port No.
(Unit No. + Slot No. + Circuit No.)/Virtual Port No.
PRECAUTION:
(1) When deleting a station number (Single Line or Multiline Terminal), be sure to delete Call Pickup
data (CM16), ACD/UCD Group data (CM17) and Station Hunting Group data (CM18) in advance.
(2) After assigning the data for CD-2BRIA (ISDN Telephone), you must unplug the circuit blades,
then plug them again (After unplugging the circuit blade, you must wait for 30 seconds before
plugging the circuit blade again.).
(3) 5 or more digits station number should not be assigned when the following features are used.
• SMDR/PMS
• Front Desk Terminal
ASSIGNMENT PROCEDURE:
ST DE
+ 10YY +
STATION
DE NUMBER NUMBER
+
(1-10 digits)
DATA TABLE:
Y
No. MEANING
00 TDM terminal/Trunk
registration
See "About Unit
number, Slot number
and Circuit number"
See "Setting
method of Port num-
ber/Station number in
Dual port mode"
STATION NUMBER, TRUNK NUMBER, BLADE NUMBER
PHYSICAL PORT No. (UNIT No. + SLOT No. + CIRCUIT No.)/
+
VIRTUAL PORT No. (3-6 digits)
TRUNK BLADE
NUMBER
+
STATION NUMBER (A)
DATA MEANING
XXYYZZ Physical Port num-
ber
XX: Unit number
(01-50)
YY: Slot number
(01-18)
ZZ: Circuit num-
ber (01-32)
EXE
SETTING DATA
DATA
X- Single Line station number
XXXX (1-8 digits)
XXXX
X: 0-9, A (*), B (#)
3-139
+
RELATED
COMMAND
MEANING
CM12
CM13
Continued on next page
NWA-033623-001 Rev.8.1
CM10
91ch3002.fm
APRIL/16/2010