Cat Operation - NEC UNIVERGE SV8300 Command Manual

CAT OPERATION

When setting the system data, it is necessary to enter the following three kinds of data.
• Command Code
• First Data
• Second Data
The operation is explained below.
(1) To confirm the existing system data
+ Command Code +
ST
With the above entry completed, the present second data is displayed on the LCD.
If the second data is not assigned yet, either the default value or "NONE" is displayed.
(2) To assign (change) the system data
+ Command Code +
ST
With pressed, "OK" is displayed on the LCD.
EXE
To confirm the data assigned, press
(3) Use of button and
S
• If is pressed after setting the second data (after
S
is displayed.
• If is pressed after setting the second data (after
–
displayed.
+ First Data +
DE
+ First Data +
DE
after entering the fist data.
DE
button
–
1-24
Chapter 1 HOW TO USE CAT
DE
+ Second Data +
DE
has been pressed), the next first data
EXE
has been pressed), the last data is
EXE
CAT OPERATION
EXE
NWA-033623-001 Rev.8.1
91ch1001.fm