NEC UNIVERGE SV8300 Command Manual page 123

COMMAND CODE TITLE:
08
581 Number display on the called PS when calling from Sub Line
[8300R3.5]
NOTE:
The number displayed on the called PS is as follows when this command is set to "1".
- My Line Number is displayed when CM08>502 is set to "0".
- Sub Line Number is displayed when CM08>502 is set to "1".
583 Whether the calling number is automatically stored or not for
the station call via CCIS
584 Caller ID sent to ISDN telephone when terminating a call from
Single Line Telephone/Multiline Terminal to ISDN telephone
585 Whether the service which is set to a group member station is
effective when the group members are called by Group Feature
Key
NOTE:
When the second data of CM08>585 is set to 0, the following services are effective.
Call Forwarding-All Calls/Split Call Forwarding-All Calls/Call Forwarding-All Calls of Mobility
Access/Do Not Disturb/Transfer the call to station set Do Not Disturb (CM51 Y=10)/Call Forwarding-
Logout
588 CID Call Back when an incoming call is forwarded, when a
station to which a call terminated is busy, or when a station to
which a call terminated is set Do Not Disturb
NOTE: CID Call back by this command is available under the following conditions.
• The Multiline Terminal station line is set to Call Forwarding-All Calls/Call Forwarding-Busy Line/
Call Forwarding-No answer/Call Forwarding-IP Station logout when a trunk call is terminated.
• The Multiline Terminal station line is set to Do Not Disturb when a trunk call is terminated.
• The Multiline Terminal station line received the incoming call is busy when a trunk call is termi-
nated.
591 Extension state (Idle/Busy) is displayed immediately to Busy
lamp Field on DESKCON
[8300R2]
592 Setting of the Caller ID information sending format
NOTE: A system reset is required after setting this command.
BASIC SERVICES
BASIC SERVICE
0 My Line Number
1 As per CM08>502
0 To store
1 Not stored
0 Calling number assigned by CM12
Y=12, 13/CM50 Y=05
1 Originating station number
0 Effective
1 Ineffective
0 To provide
1 Not provided
0 To display
1 Not displayed
0 CCITT V.23 modem (Data Format:
ETSI)
RESET
1 Bell 202 modem
3-67
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.8.1
91ch3001.fm
JANUARY/14/2011
CM08