NEC UNIVERGE SV8300 Command Manual page 510

COMMAND CODE TITLE:
67
Y
No. MEANING
00 NOTE 3: The table below shows the default setting of the CODEC List.
Priority
* A-law/µ-law depends on CPU or CM04 Y=10-59.
NOTE 4:
G.722 (Wide Band Codec) is available only when using DT700 Series (DT730/DT750)/SP350/VoIP-
DB (PZ-64IPLA/PZ-128IPLA)/Standard SIP station.
NOTE 5:
Although G.722 (Wide Band Codec) is not available for VoIPDB (PZ-64IPLC-A/PZ-128IPLC-A),
when only G.722 is set on the CODEC list, the CODEC is converted into G.711. However, in this state,
when the opposite office connected via IPT (P2P CCIS) is also set to G.722 only, a call is not available
because there is no available CODEC. Therefore, set this data including the available CODEC
(G.711 or G.729a).
NOTE 6:
G.723.1 is not available when using DT700 Series/D
VoIPDB (IP-PAD/IPT [P2P CCIS])/Standard SIP station.
LOCATION DATA ASSIGNMENT
1ST DATA
DATA MEANING
CODEC Type
1
2
3 G.723.1
2ND DATA
DATA MEANING
G.711*
G.729a
term
IP INASET/D
3-454
RELATED
COMMAND
Payload Size
40 ms.
40 ms.
30 ms.
term
SP30/SP350/MH240/
Continued on next page
NWA-033623-001 Rev.8.1
91ch3005.fm
JANUARY/31/2012
CM67