NEC UNIVERGE SV8300 Command Manual page 407

COMMAND CODE TITLE:
41
1ST
Y MEANING
DATA
0 141 Conference (built-in
CPU) forced release
timer
[8300R2]
142 D11 data receiving
time after PSW (For
DLC)
[8300R2]
BLADE RESET
144 Interval Time of Blade
Locking up check
[8300R2]
145 Timer that monitors a
start of DT300/DT700
Series
[8300R2]
SYSTEM TIMER DATA
DEFAULT
NONE 01 02 03 .........................................................24
7 hours 1
NOTE: If this data is set to "00", forced release is not provided.
NONE 03 04 05 .........................................................30
3 ms. 3
NOTE:
NONE 01 02 03 .........................................................10
25.8 8.6 17.2 25.8........................................................86
seconds
NOTE 1:
When no signal return from blade during four intervals of
transmission cycle, the system judges that the blade is
locked up and the blade reset is executed.
When this data is set to default, the blade reset is executed
about 100 (25.8 by four) seconds later after locked up.
NOTE 2:
This data is effective when CM08>921 is set to "1".
NONE 03 04 05 .........................................................20
3 3
minutes
NOTE 1: This data is effective only for power failure transfer with
a BRT.
NOTE 2: When a power failure is returned to normal condition
while Multiline Terminal for power failure is busy,
DT700 Series calling is kept between the time of power
failure restoration and the time set by this data.
2ND DATA
TIMER
2 3 ..........................................................24
4 5 ..........................................................30
When DESKCON is accommodated, set this
data to "06".
4 5 ..........................................................20
3-351
CM41
INCREMENT
UNIT
1 hour
1 ms.
8.6 seconds
1 minute
Continued on next page
NWA-033623-001 Rev.8.1
91ch3004.fm
JANUARY/14/2011