NEC UNIVERGE SV8300 Command Manual page 404

COMMAND CODE TITLE:
41
1ST
Y MEANING
DATA
0 123 Timing of Caller ID
station until sending
Caller ID signal after
the first ringer begins
to send
RESET
130 Expire value for
DT700 Series REGIS-
TER (Day)
131 Expire value for
DT700 Series REGIS-
TER (Hour)
132 Expire value for
DT700 Series REGIS-
TER (Minute)
SYSTEM TIMER DATA
DEFAULT
NONE 00 01 02 .........................................................25
1500 ms. 0 100 200 ......................................................2500
(CM08>
592: 0)/
2500 ms.
(CM08>
592: 1)
NONE 00 01 02 .........................................................99
3 minutes 0
NOTE 1: Usually, this data setting is not required.
NOTE 2: This data implies the expire value for the DT700 Series
REGISTER (terminal registration) and is set by the
combination of CM41 Y=0>130-132 (day/hour/minute).
When CM41 Y=0>130-132 (day/hour/minute) are all set
to NONE, the expire value "180 seconds" is set as de-
fault.
NOTE 3: The DT700 Series updates the REGISTER at half interval
of the value set by this data.
NOTE 4: The load to SV8300 increases if small amount of data
(such as 1 minute) is set. Therefore, it is recommended to
set the value more than 180 seconds.
NOTE 5: After setting this data, a reset of the terminal is required.
NONE 00 01 02 .........................................................23
3 minutes 0
NOTE:
NONE 00 01 02 .........................................................59
3 minutes 0
NOTE:
2ND DATA
TIMER
1 2 ..........................................................99
1 2 ..........................................................23
See NOTE 1 through NOTE 5
Y=0>130.
1 2 ..........................................................59
See NOTE 1 through NOTE 5
Y=0>130.
3-348
INCREMENT
UNIT
100 ms.
1 day
1 hour
on CM41
1 minute
on CM41
Continued on next page
NWA-033623-001 Rev.8.1
91ch3004.fm
JANUARY/31/2012
CM41