Philips Sopho 2000 IPS User Manual page 144

When the signal pattern of the called number sent from T1 network is as shown below, assign the following
data, if required.
Called Number=NPA + NNX + Called Station Number
START
CM35 Assign the Digit Addition/Deletion on the
incoming calls.
CM20 Assign the access code for LCR Group 0-3.
CM8A Assign an area code for Intra-Office
Termination.
END
NOTE:
FGD-Format and ANI-Format are:
SIGNAL PATTERN
FGD-Format
ANI-Format
HARDWARE REQUIRED
DTI card
MFR card
DESCRIPTION
CALLED NUMBER
MF Signal
DP Signal
AUTOMATIC NUMBER IDENTIFICATION (ANI)
• Y=17 Digit Addition/Deletion Assignment
(1) 00-63: Trunk Route No.
(2) 00-09: "0" add -"9" add
10 : 2-digit addition (CM50 Y=00>0)
11 : 1 digit deletion
12 : 2 digits deletion
15 : Addition/deletion is not performed
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) A126: LCR Group 0
A127: LCR Group 1
A128: LCR Group 2
A129: LCR Group 3
• Y=4005-4007 Area Code Development
No. 5-7
(1) X-XXXXXXXX: Area Code, 1-8 digits
(2) 8000: Intra-Office Termination
– 126 –
DATA
ANI
MF Signal
MF Signal
NWA-008845-001 Rev.5.0
32ch1002.fm