Philips Sopho 2000 IPS User Manual page 199

A
CMDB Assign the destination station for Day Mode/
Night Mode, if required. A maximum of 12
digits are available.
NOTE: If assigning the destination station
number as below, the terminating
system overrides CM30 Y=02/03 for
the selected Development Table.
* * * * 0 2: Trunk-Direct Appearances
* * * * 0 3: Trunk-Direct Appearances + TAS
* * * * 0 4: Direct-in Termination
* * * * 0 9: Automated Attendant
* * * * 1 0: Attendant Console + TAS
* * * * 1 1: Attendant Console + Trunk-Direct Appearances
* * * * 1 2: Attendant Console + Trunk-Direct Appearances +
TAS
* * * * 1 4: Termination to Attendant Console
* * * * 1 6: Direct Inward System Access (DISA)
* * * * 3 1: DID, Tie Line, and any call which is not handled by
the PBX
NOTE:
The destination station number can
also be an LCR access code plus
outside telephone number.
Specify the ringing tone for each calling
number, if required.
Specify which is displayed on the LCD, when
receiving both the calling number and the
name from network on incoming call.
Specify whether the Call Waiting is set for
each calling number or not.
B
DESCRIPTION
• Y=01 Day Mode
• Y=02 Night Mode
(1) 0-1499: Development Table No.
(2) Destination Station No. (Maximum 12
digits)
• Y=04 Ringing Tone Assignment
(1) 0-1499: Development Table No.
(2) 0 : Depends on CM35 Y=33
1 : Not used
2 : Internal Ringing Tone
3 : External Ringing Tone
• Y=05 Calling Number/Name Display
(1) 0-1499: Development Table No.
(2) 0 : Calling Number Display
1 : Calling Name Display
• Y=06 Call Waiting
(1) 0-1499: Development Table No.
(2) 0 : Not available
1 : Available
NOTE:
– 181 –
CALLER ID CLASS
DATA
This data is effective when the
2nd data of CM35 Y=59 is 1.
NWA-008845-001 Rev.5.0
32ch1003.fm