Call Forwarding - Philips Sopho 2000 IPS User Manual

CALL FORWARDING

To set or reset the Call Forwarding service from a MAT/CAT, use the following command.
START
CME6 Use Y=00-03 for Call Forwarding and Y=04-
05 for Split Call Forwarding. To reset the
service, assign "CCC" to the second data of
each Y No.
END
DESCRIPTION
• Y=00 Call Forwarding-All Calls
• Y=01 Call Forwarding-Busy Line
• Y=02 Call Forwarding-No Answer
• Y=03 Call Forwarding-Busy Line/No An-
swer
(1) X-XXXXXXXX: Station No.
(2) Destination No.
<Destination=Extension>
X-XXXXXXXX: Station No.
<Destination=Outside Party>
X-XXXX +
X-XXXX: Outgoing Trunk/LCR Group
,
YY···Y : Called No. (Maximum 26
<Destination=Attendant>
E000: Attendant Console
• Y=04 Split Call Forwarding-ALL Calls
• Y=05 Split Call Forwarding-Busy Line/No
Answer
(1) X-XXXXXXXX: Station No.
(2) 0: Target Station for Split Call Forwarding
(Block 0)/ATT
1: Target Station for Split Call Forwarding
(Block 1)
2: Target Station for Split Call Forwarding
(Block 2)
3: Target Station for Split Call Forwarding
(Block 3)
4: Target Station for Split Call Forwarding
(Block 4)
5: Target Station for Split Call Forwarding
(Block 5)
6: Target Station for Split Call Forwarding
(Block 6)
7: Target Station for Split Call Forwarding
(Block 7)
8: Target Station for Call Forwarding
9: Station Speed Dialing (Block 0)
– 136 –
CALL FORWARDING
DATA
,
+ YY···Y
Access Code (1-4 digits)
: Separate Mark
digits)
NWA-008845-001 Rev.5.0
32ch1003.fm