Philips Sopho 2000 IPS User Manual page 314

C
CM41 Specify the various timing parameters, if
required.
CM20 Assign an access code for the DTI trunk route.
NOTE: The Least Cost Routing or Route
Advance feature is also available
for call origination via the DTI.
Refer to the following feature
programming.
LEAST COST ROUTING-3/6
DIGIT
ROUTE ADVANCE
END
DESCRIPTION
Page 425
Page 599
• Y=3
(1) 00: Release Signal Detect Timing
(2) 01-15: 64-960 ms. (64 ms. increments)
If no data is set, the default setting is 128 ms.
• Y=3
(1) 01: Answer Signal Detect Timing
(2) 01-15: 32-480 ms. (32 ms. increments)
If no data is set, the default setting is 128 ms.
• Y=3
(1) 02: Wink Signal width
(2) 01-15: 64-512 ms. (32 ms. increments)
If no data is set, the default setting is 32 ms.
• Y=3
(1) 03: Wink/Delay Detection Timeout
(2) 01-15: 1-15 seconds (1 second increments)
If no data is set, the default setting is 7 seconds.
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) 100-163: Trunk Route 00-63
– 296 –
DIRECT DIGITAL INTERFACE
PROGRAMMING
DATA
NWA-008845-001 Rev.5.0
32ch1005.fm
JULY/01/2006