Philips Sopho 2000 IPS User Manual page 657

C
CMD001 Specify the maximum accumulation rate of
billing memory for external alarm output when
the rate exceeds assigned value.
NOTE 1:
The condition for external alarm is as follows;
(a) The accumulation rate for the following limit value approaches the value set by
(b) The accumulation rate for the following limit value approaches full.
(c) The accumulation rate for the following limit value is less than the assignable range
[Limit Value]
NOTE 2: ON/OFF control for external relay on DK00 card and fault information display can be per-
formed with the condition for external alarm as above.
For case (a): External relay ON/OFF set by CMD000>126
For case (b): External relay ON/fault information display set by CMEA Y=2>28
For case (c): External relay OFF/fault information display set by CMEA Y=2>38
D
DESCRIPTION
CMD001>229 in advance.
set by CMD001>229 or is cleared the stored billing memory.
- Limit value of remaining Call Record memory set by CMD003>24/29
Fault information display set by CMEA Y=2>28
STATION MESSAGE DETAIL RECORDING (SMDR)
(1) 229
(2) 0 : 80%
50-99: 50-99%
– 639 –
PROGRAMMING
DATA
NWA-008845-001 Rev.5.0
32ch1010.fm
JULY/01/2006