Philips Sopho 2000 IPS User Manual page 846

When printing the set/cancel/execution record of hotel features such as Automatic Wake Up/Do Not Dis-
turb/Room Cutoff/Message Waiting, do the following programming in addition to the programming of MP
built-in PMS on IP.
[Series 3600 software required]
AP Initialization (PN-AP00-B/PN-AP00-D with MRCA program)
You can distinguish whether the AP is active or not by the RUN lamp indication. The RUN lamp flashes
on green color when the AP is in active.
When you install the AP00 at first time, you should assign the data shown below.
START
CM05 Assign an AP number to the AP00 card. The
AP number must match the SENSE switch set-
ting on the AP00 card.
On the AP00 card, set SW1 switch as shown
below.
SW 1
ON
CMDD99 Load the initial data into the AP00 card.
On the AP00 card, set the SW1 switch as
shown below.
SW 1
ON
END
DESCRIPTION
4
3
: POSITION TO BE SET
2
1
AP OFF LINE
4
3
: POSITION TO BE SET
2
1
PROPERTY MANAGEMENT SYSTEM INTERFACE
• Y=0
(1) 04-15, 20-31: AP No.
(2) 45: PN-AP00-B/PN-AP00-D card with
INITIAL
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
(1) 0000
(2) CCC
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
– 828 –
HOTEL SYSTEM PROGRAMMING
DATA
MRCA program
NWA-008845-001 Rev.5.0
32ch2001.fm
JULY/01/2006