Philips Sopho 2000 IPS User Manual page 675

G
CMDD01 Specify maximum accumulation rate of billing
memory for external alarm output when the
rate exceeds assigned value.
NOTE 1:
The condition for external alarm is as follows;
(a) The accumulation rate for the following limit value approaches the value set by
(b) The accumulation rate for the following limit value approaches full.
(c) The accumulation rate for the following limit value is less than the assignable range
[Limit Value]
NOTE 2: ON/OFF control for external relay on DK00 card and fault information display can be per-
formed with the condition for external alarm as above.
For case (a): External relay ON/OFF set by CMDD00>126
For case (b): External relay ON/fault information display set by CMEA Y=2>28
For case (c): External relay OFF/fault information display set by CMEA Y=2>38
CMDD04 Specify the direction for sending detail infor-
mation on C.O./Tie Line outgoing calls.
H
DESCRIPTION
CMDD01>229 in advance.
set by CMDD01>229 or is cleared the stored billing memory.
- Limit value of remaining Call Record memory set by CMDD02>0/1/2
Fault information display set by CMEA Y=2>28
STATION MESSAGE DETAIL RECORDING (SMDR)
(1) 229
(2) 50-99: 50%-99%
80 : 80%
(1) XX 00: Send detail information of C.O./
XX: Service Class No. assigned by CM12
Y=45/CM60 Y=32
(2) 0 : Not sent
1 : To send
(1) XX 02: Send detail information of C.O./
XX: Service Class No. assigned by CM12
Y=45/CM60 Y=32
(2) 0 : Not sent
1 : To send
– 657 –
PROGRAMMING
DATA
Tie Line outgoing calls to SMDR
terminal 0
Tie Line outgoing calls to SMDR
terminal 1
NWA-008845-001 Rev.5.0
32ch1010.fm
JULY/01/2006