Philips Sopho 2000 IPS User Manual page 311

30DTI Assignment
NOTE: When using the PN-DTA card, the following switch setting is required to set E1 interface.
SW3-1: OFF (E1 mode), SW3-2: OFF (DTI mode)
START
CM05 Assign an AP number to the DTI card.
The AP number assigned must match the
SENSE switch setting on the DTI card.
Specify the AP highway channel for 30DTI
card.
CM07 Assign trunk number to each channel number
on the DTI card. Channel 0 and 16 cannot be
assigned.
NOTE:
CM30 Assign a trunk route number to each DTI.
NOTE:
A
DESCRIPTION
The system allocates time slots to
consecutive channels from lowest to
the highest channel number as-
signed.
To minimize the number of time slots
allocated, assign trunk numbers to
consecutive channels on each card.
Never skip channels in CM07.
DTI route must be separated from
any analog trunk route.
• Y=0
(1) 04-15, 20-31: AP No.
(2) 09: DTI card
INITIAL
• Y=1
(1) 04-15, 20-31: AP No.
(2) 0 : Use Expanded Highway channel
INITIAL
1 : Use Basic Highway channel
• Y=01
(1) XX ZZ
XX: 04-15, 20-31: AP No. assigned by
INITIAL
ZZ : 01-15, 17-31: Channel No. of 30DTI
(2) D000-D255: Trunk No.
Any trunk number already assigned by
CM10/CM14 cannot be used.
• Y=00
(1) 000-255: Trunk No. assigned by CM07
(2) 00-63: Trunk Route No.
– 293 –
DIRECT DIGITAL INTERFACE
PROGRAMMING
DATA
(128 time slots)
(128 time slots)
CM05 Y=0
Y=01
NWA-008845-001 Rev.5.0
32ch1005.fm
JULY/01/2006