Hotel/Motel Did Number Allocation To Guest Station - Philips Sopho 2000 IPS User Manual

HOTEL/MOTEL DID NUMBER ALLOCATION TO GUEST STATION

[Series 3400 software required]
PROGRAMMING
START
CM08 Specify the DID Development Table for guest
station.
NOTE:
CM76 Assign the Number Conversion Block number
for Development Table 0.
Assign the Number Conversion Block number
for Development Table 1.
Allow Hotel/Motel DID number allocation to
guest station.
Assign the data for interpreting the digits re-
ceived.
NOTE:
END
HARDWARE REQUIRED
PMS
AP00-B/AP00-D card with MRCA program (for MP built-in PMS on IP)
DESCRIPTION
Set the second data the same as the
DID Development Table number as-
signed by CM35 Y=170.
This programming is effective when
the destination station number from
PMS is not set.
HOTEL SYSTEM PROGRAMMING
HOTEL/MOTEL DID NUMBER ALLOCATION TO GUEST STATION
(1) 824
(2) 0 : Development Table 1 for DID No. as-
signed by CM76 Y=90
1 : Development Table 0 for DID No. as-
signed by CM76 Y=00
• Y=00
(1) X-XXXX: DID No.
(2) 000-999: Number Conversion Block No.
• Y=90
(1) X-XXXXXXXX: DID No.
(2) 000-999: Number Conversion Block No.
• Y=32
(1) 000-999: Number Conversion Block No.
(2) 0: Available
• Y=01 Day Mode
• Y=02 Night Mode
• Y=03 Mode A
• Y=04 Mode B
(1) 000-999: Number Conversion Block No.
(2) X-XXXXXXXX: DID station No.
D04: Direct-In Termination
– 799 –
DATA
assigned by CM76 Y=00/90
assigned by CM76 Y=00/90
NWA-008845-001 Rev.5.0
JUNE/01/2007
32ch2001.fm