Philips Sopho 2000 IPS User Manual page 740

B
CM08 Specify the processing for an incoming call
when all UCD stations are busy.
Specify the processing for a held call after set-
ting the UCD Busy Out.
Specify that the transferred C.O. call from a
station or an attendant is placed into queuing
mode when all UCD stations are busy.
NOTE:
This data is only effective when
CM08>212 is set to 1.
Enable the UCD Busy Out set and reset from
the secondary extension.
END
DESCRIPTION
UNIFORM CALL DISTRIBUTION (UCD)
(1) 212
(2) 0 : Busy Tone Connection
1 : Queuing
(1) 214: For the held call from Tie Line
(2) 0 : Reconnected by Switch Hook Flash
1 : Disconnected
(1) 215: For the held call from C.O. Line
(2) 0 : Reconnected by Switch Hook Flash
1 : Disconnected
(1) 227
(2) 0 : The call is placed into queuing mode
1 : Recall to the transferring station when
the call is transferred from station, or
Attendant Camp-On is set when the
call is transferred from Attendant
(1) 442
(2) 0 : Available
1 : Not available
– 722 –
DATA
NOTE
NWA-008845-001 Rev.5.0
32ch1011.fm