Philips Sopho 2000 IPS User Manual page 301

A
CMAA Assign the necessary functions to the DTI
card.
After entering the data, set the MB switch on
the DTI card to UP, and then to DOWN, for
DTI initialization.
NOTE: The following table shows the rela-
tionship between CMAA Y=01 and
CMAA Y=02.
CMAA Y=01
(FRAME
CONFIGURATION)
24-Multi Frame [1]
12-Multi Frame [0]
[ ]: Indicates 2nd data
Select the card for DTI T1 interface.
CM30 Assign a trunk route number for tie line inter-
face to each DTI.
NOTE: The DTI route must be separated
from any analog trunk route.
CM35 Assign trunk route data to each DTI route.
B
DESCRIPTION
DTI INITIAL
CMAA Y=02
(ZERO CODE
SIGNALING
SUPPRES-
SION)
B8ZS
Not available
Transparent
[1]
Available [0] B7
INITIAL
• Y=00 Data Mode
(1) 04-15, 20-31: AP No. assigned by CM05
(2) 0: Based on AT&T Specifications
• Y=01 Frame Configuration
(1) 04-15, 20-31: AP No. assigned by CM05
(2) 0 : 12-Multi Frame (D4)
1 : 24-Multi Frame (ESF)
• Y=02 Zero Code Suppression
(1) 04-15, 20-31: AP No. assigned by CM05
(2) 0 : Available (Non Transparent)
1 : Not available (Transparent)
• Y=03
(1) 04-15, 20-31: AP No. assigned by CM05
(2) 7 : Associated Channel Interoffice
Signaling
• Y=14
(1) 04-15, 20-31: AP No. assigned by CM05
(2) 0 : PN-24PRTA/PN-DTA
1 : PN-24DTA-C
• Y=00
(1) 000-255: Trunk No. assigned by CM07
(2) 00-63: Trunk Route No.
• Y=00 Kind of Trunk Route
(1) 00-63: Trunk Route No.
(2) 04: Tie line trunk
– 283 –
DIRECT DIGITAL INTERFACE
PROGRAMMING
DATA
Y=0
Y=0
Y=0
Y=0
Y=0
Y=01
NWA-008845-001 Rev.5.0
32ch1005.fm
JULY/01/2006