Cid Call Routing - Philips Sopho 2000 IPS User Manual

CID CALL ROUTING

PROGRAMMING
For DID on ISDN, T1-ANI, MFC incoming calls:
(See SAMPLE DATA PROGRAMMING
START
CM35 Provide the incoming trunk route with digit
conversion.
Specify the Development Table for digit con-
version.
CM76 Assign the Number Conversion Block number
for Development Table 0.
NOTE:
Assign the Number Conversion Block number
for Development Table 1.
NOTE:
A
1.
DESCRIPTION
When the Number Conversion Block number is assigned for CID Call Routing, do not use
the same Number Conversion Block number for the DID feature.
When the Number Conversion Block number is assigned for CID Call Routing, do not use
the same Number Conversion Block number for the DID feature.
Page 207)
• Y=18
(1) 00-63: Trunk Route No.
(2) 0: To provide
• Y=170
(1) 00-63: Trunk Route No.
(2) 0 : Development Table 1
3 : Development Table 0
• Y=00
(1) X-XXXX: DID No. /Called No.
(2) 000-999: Number Conversion Block No.
• Y=90
(1) X-XXXXXXXX: DID No. /Called No.
(2) 000-999: Number Conversion Block No.
– 202 –
CID CALL ROUTING
DATA
NOTE
NOTE
NWA-008845-001 Rev.5.0
32ch1004.fm