Enhanced 911 - Philips Sopho 2000 IPS User Manual

ENHANCED 911

PROGRAMMING
START
CM05 Assign an AP number to the 911 Sender trunk.
The AP number is given by the SENSE switch
on the 911 Sender trunk.
CM06 Assign 911 Sender trunk number to each 911
Sender trunk.
CM08 Send ANI signal to the network on Enhanced
911.
Specify whether the Sender Tone will be sent
when a call originated, or not.
CM09 Provide the System with Enhanced 911.
CM31 Specify that all circuits on the 911 Sender
trunk are used as sender.
NOTE:
A
DESCRIPTION
The AP number 0-3 corresponds to
the AP numbers assigned by CM05
(04-15, 20-31) as shown below:
CM31 Y=2 CM05 Y=0
AP Number 0: AP Number X
AP Number 1: AP Number Y
AP Number 2: AP Number Z
AP Number 3: AP Number W
(X<Y<Z<W)
• Y=0
(1) 04-15, 20-31: AP No.
INITIAL
(2) 08: 911 Sender Trunk (4RSTB card)
• Y=04
(1) 00-15: 911 Sender Trunk No.
(2) XX Z
INITIAL
XX: 04-15, 20-31: AP No. assigned by
Z : 0-3: Circuit No.
(1) 474: Enhanced 911
(2) 0: To send
(1) 475: Sending of Sender Tone
(2) 0 : Not sent (No tone)
1 : To send
(1) 52: Enhanced 911
(2) 0 : To provide
INITIAL
• Y=2
(1) 0-3: AP No.
(2) 0: All circuits are used as the 911 Sender
INITIAL
– 354 –
ENHANCED 911
DATA
CM05
NOTE
NWA-008845-001 Rev.5.0
32ch1006.fm