Philips Sopho 2000 IPS User Manual page 202

(6) Data Assignment for multiple CIR Trunk (PN-4RSTC)
NOTE: The following procedure is required only when using PN-4RSTC as CIR Trunks.
The development data by CMDC and CMDB are assigned toward the first CIR Trunk which has been
assigned a minimum AP number. When providing multiple CIR Trunks, save the development data
and load them for the other CIR Trunks according to the following steps.
For detail of MAT Load/Save operations, refer to the Maintenance Manual.
STEP1: After assignment of CMDC and CMDB, save the office data by MAT.
At this time, specify the AREA Number including the MEMORY ADDRESS 00900-2FFFF.
STEP2: Set the MB switch to ON (UP) on the first CIR Trunk with minimum AP number X.
AP Number X< Y< Z< W
STEP3: As for the second CIR Trunk, change the AP number Y to X by CM05 and by the SENSE
switch.
STEP4: Set the SW1-1 through SW1-4 to ON on the second CIR Trunk.
Clear the memory for CMDC and CMDB by CMDB Y=90.
Set the SW1-1 through SW1-4 to OFF on the second CIR Trunk.
STEP5: Load the office data saved in STEP1 by MAT.
STEP6: As for the second CIR Trunk, restore the AP number X to Y by CM05 and by the SENSE
switch.
Jump to STEP17 if no more CIR Trunks are provided.
STEP7: Set the MB switch to ON (UP) on the second CIR Trunk with AP number Y.
STEP8: As for the third CIR Trunk, change the AP number Z to X by CM05 and by the SENSE switch.
STEP9: Set the SW1-1 through SW1-4 to ON on the third CIR Trunk.
Clear the memory for CMDC and CMDB by CMDB Y=90.
Set the SW1-1 through SW1-4 to OFF on the third CIR Trunk.
STEP10: Load the office data saved in STEP1 by MAT.
– 184 –
CALLER ID CLASS
NWA-008845-001 Rev.5.0
32ch1003.fm