Philips Sopho 2000 IPS User Manual page 707

A
CM35 When you use the ODT card for 2-wire E&M
trunk, set CM35 Y=100 to 14/15.
NOTE: When using Series 3600 software or
later, a reset of the MP card is not
required after this command is set/
changed.
When changing the data with online,
the data is valid after the trunk card
is unplugged and plugged in.
Assign trunk route data to the trunk route num-
ber assigned by CM30 Y=00.
B
DESCRIPTION
INITIAL
• Y=100 Terminating and Balanced Network
Impedance
(1) 00-63: Trunk Route No.
(2) 14: 2-wire E&M Trunk (for regular)
15: 2-wire E&M Trunk (for long line)
NONE : For regular
• Y=00 Kind of Trunk Route
(1) 00-63: Trunk Route No. (01/02)
(2) 04: Tie Line
• Y=01
(1) 00-63: Trunk Route No. (01/02)
< Incoming > < Outgoing >
(2) 2 : DP-10PPS
4 : DTMF
7 : DTMF/DP
• Y=02 IC/OG
(1) 00-63: Trunk Route No. (01/02)
(2) 1 : Incoming trunk
2 : Outgoing trunk
3 : Bothway trunk
• Y=04 Answer Signal from distant office
(1) 00-63: Trunk Route No. (01/02)
(2) 2 : Arrive
7 : Not arrive
• Y=05 Release Signal from distant office
(1) 00-63: Trunk Route No. (01/02)
(2) 1 : Arrive
• Y=08 Sending of Dial Pulse
(1) 00-63: Trunk Route No. (01/02)
(2) 3 : Send
– 689 –
TIE LINES
DATA
DP-10PPS
DTMF
DTMF
NWA-008845-001 Rev.5.0
32ch1011.fm
DECEMBER/02/2005