Did Digit Conversion - Philips Sopho 2000 IPS User Manual

DID DIGIT CONVERSION

PROGRMMING SUMMARY FOR DID DIGIT CONVERSION
(1) Specify whether the DID Digit Conversion is provided for each trunk route by CM35 Y=18.
(2) To provide the DID Digit Conversion, set the following data.
STEP1: Specify the Development Table for DID Digit Conversion to each trunk route by CM35 Y=170.
STEP2: Assign the number of digits to be received on DID and the number of digits to be converted on
DID to each trunk route/each Development Table by CM35 Y=12, 78/CM35 Y=171, 172.
STEP3: Set the Number Conversion Block number for each Development Table by CM76 Y=00, 90.
STEP4: Assign the data for interpreting the received digits to each Number Conversion Block number
by CM76 Y=01-04.
CM35 Y=18
CM35 Y=170
DID Digit Conversion Programming Procedure
Received number=Station number
1 : Not provided DID Digit Conversion
0: To provide DID Digit Conversion
3 : Development
Table 0
0: Development
Table 1
CM35 Y=12 CM35 Y=78
Number of Number of
digits to be digits to be
received: converted:
1-4 digits 2-4 digits
CM35 Y=172 CM35 Y=171
Number of Number of
digits to be digits to be
received: converted:
1-14 digits 1-8 digits
– 303 –
DIRECT INWARD DIALING (DID)
DID DIGIT CONVERSION
DID station
CM76 Y=00
DID number
CM76
Number
Y=01-04
Conversion
Block number
The data setting
for interpreting
the digits re-
ceived to each
CM76 Y=90
Number Con-
version Block
DID number
number
Number
Conversion
Block number
DID station
NWA-008845-001 Rev.5.0
32ch1006.fm