Philips Sopho 2000 IPS User Manual page 222

B
CM76 Assign the data for interpreting the digits
received.
NOTE: Day/Night Mode, Mode A/B can be
specified according to following
conditions.
1st priority:
Specified by tenant number for each
calling party number (CM76 Y=09)
2nd priority:
Specified by trunk tenant number
(CM30 Y=01)
3rd priority:
Specified by tenant number for each
DID number (CM76 Y=09)
When CM76 Y=01/02/03/04 is set to "D13"
(TAS), assign the terminating tenant for Day/
Night Mode, Mode A/B per each calling party
number.
NOTE:
When you set the other CM76 data (Y=10, 11, 13-16, 18-25) for the Development Block
number assigned by CM2A Y=50/51/52, these settings are also effective for each calling
party number.
END
DESCRIPTION
• Y=01 Day Mode
• Y=02 Night Mode
• Y=03 Mode A
• Y=04 Mode B
(1) 000-999: Development Block No. assigned
(2) X-XXXXXXXX: Station No. to be
DXX: Change Terminating System to:
D02: Trunk-Direct Appearances
D03: Trunk-Direct Appearances +
D04: Direct-In Termination
D09: Automated Attendant
D10: Attendant Console + TAS
D11: Attendant Console + Trunk-
D12: Attendant Console + Trunk-
D13: TAS
D14: Attendant Console
D16: DISA
• Y=05 Day Mode
• Y=06 Night Mode
• Y=07 Mode A
• Y=08 Mode B
(1) 000-999: Development Block No. assigned
(2) 00-63: Trunk Tenant No.
– 204 –
CID CALL ROUTING
DATA
by CM2A Y=50/51/52
terminated
TAS
Direct Appearances
Direct Appearances + TAS
by CM2A Y=50/51/52
NWA-008845-001 Rev.5.0
32ch1004.fm