Block %2 Interpolation Type Not Allowed In Stock Removal Contour; Block %2 Incorrect Stock Removal Contour; Block %2 Preparation Of Contour Has Been Restarted; Block %2 Contour Programm Does Not Contain Enough Contour Blocks - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
10930
[Channel %1: ] Block %2 interpolation type not allowed in stock removal contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The following types of interpolation are allowed in the contour program for stock removal: G00, G01, G02, G03, CIP,
CT
Reaction:
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
In the contour subroutine, program only path elements that consist of straight lines and arcs.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
10931
[Channel %1: ] Block %2 incorrect stock removal contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The following errors occurred in the subroutine for the contour during stock removal:
- Full circle
- Overlapping contour elements
- Wrong start position
Reaction:
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
The errors listed above must be corrected in the subroutine for the stock removal contour.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
10932
[Channel %1: ] Block %2 preparation of contour has been restarted
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The first contour preparation/contour decoding run must be terminated with EXECUTE.
Reaction:
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program the keyword EXECUTE to terminate the contour preparation in the part program before again calling up con-
tour segmentation (keyword CONTPRON).
Program
Clear alarm with the RESET key. Restart part program
Continuation:
10933
[Channel %1: ] Block %2 contour programm does not contain enough contour blocks
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The contour program contains:
- Less than 3 contour blocks with CONTPRON
- No contour blocks with CONTDCON
102
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
