Block %2: Max. No. Of Value Lines For Recording Exceeded; Block %2: Check Distance From Measuring Point 1 To Measuring Point 2; Block %2: Check Circular Feed; Block %2: Parameters _Setv[0...3] Or _Setv[4...7] Are Identical - Siemens Sinamics S120 Diagnostic Manual

61363 [Channel %1: ] Block %2: Max. no. of value lines for recording exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Maximum number of value lines exceeded.
Alarm triggerd by following cycle: CYCLE105.
Remedy: Reduce the number of value lines.
Check parameter _PROTFORM[4].
61364 [Channel %1: ] Block %2: Check distance from measuring point 1 to measuring point 2
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: CYCLE998
Remedy: Check parameter incremental infeed depth (_ID)
61365 [Channel %1: ] Block %2: Check circular feed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: CYCLE979
Remedy: For 840D:
- Check parameter _RF
For 840D sl:
- Check parameter FP
61366 [Channel %1: ] Block %2: Direction of rotation for tool measurement with rotating
spindle not specified.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE971
Remedy: For 840D:
- Check parameter _CM[5] in GUD6, permissible values are 3 (corresponds to M3) and 4 (corresponds to M4)
For 840D sl:
- Check setting data 54674 $SNS_MEA_CM_SPIND_ROT_DIR, permissible values are 3 (corresponds to M3) and
4 (corresponds to M4)
61367 [Channel %1: ] Block %2: Parameters _SETV[0...3] or _SETV[4...7] are identical
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE961.
Remedy: Specify different positions for the relevant points of _SETV[0...7] .
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
443