Block %2 Error On Function Or Procedure Call, Error Code %3; Block %2 Motion Synchronous Action: Illegal Modal Id; Invalid Polynomial Number In The Fctdef Command; Too Many Technology Cycles Programmed - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
14022
[Channel %1: ] Block %2 error on function or procedure call, error code %3
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions:
An error occurred during a function or procedure call.
The cause of the error is indicated more closely by an error code.
The meaning of the error code can be found in the documentation of the function or procedure that caused the error.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14025
[Channel %1: ] Block %2 motion synchronous action: illegal modal ID
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
In modal motion synchronous actions an illegal ID number has been assigned.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
14026
[Channel %1: ] Block %2 motion synchronous action: invalid polynomial number in the
FCTDEF command
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
An FCTDEF command was programmed with a polynomial number that exceeds the maximum value set in MD28252
$MC_MM_NUM_FCTDEF_ELEMENTS.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
14027
[Channel %1: ] Block %2 motion-synchronous action: Too many technology cycles
programmed.
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
You can call a maximum of eight technology cycles with one motion-synchronous action. You exceeded the upper
limit.
146
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
