Block %2: External Tool Diameter Required For Restrictions; Block %2: Tool Diameter Larger Than Restriction; If Tool Angle Is Larger Than 90 Degrees, Tool Diameters Must Be Equal - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
Remedy: Select another retraction plane or approach a suitable interpolation point.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61276 [Channel %1: ] Block %2: External tool diameter required for restrictions
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Outer tool diameter required in case of delimitations.
Alarm triggered by following cycle: CYCLE61.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Specify the outer tool diameter.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61277 [Channel %1: ] Block %2: Tool diameter larger than restriction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Tool diameter larger than delimitation.
Alarm triggered by following cycle: CYCLE61.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a smaller tool.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61278 [Channel %1: ] Block %2: If tool angle is larger than 90°, both tool diameters must be
equal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: For tool angles larger than 90°, the two tool diameters must be identical.
Alarm triggered by following cycle: CYCLE61.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct the tool angle or the tool diameters.
Program Clear alarm with the RESET key. Restart part program
Continuation:
424
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms