Block %2: Active Radius/Diameter Setting Does Not Match Reset Setting; Block %2: The Value Of The "Axis Sequence" Parameter Is Illegal; Block %2: Blank Programmed Incorrectly; Block %2: Reference For Incremental Retraction Plane Missing - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
Remedy:
Select spindle rotation direction in tool list.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61294
[Channel %1: ] Block %2: Active radius/diameter setting does not match reset setting
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The alarm is triggered by the following cycles: E_HEAD, F_HEAD
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Before starting up the program, set G group 29 (DIAMON, DIAMOF etc.) to reflect the corresponding reset value.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61295
[Channel %1: ] Block %2: The value of the "Axis sequence" parameter is illegal
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The alarm is triggered by the following cycles: E_TCTOOL, F_TCTOOL
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Correct the "Axis sequence" parameter in the screen form
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61296
[Channel %1: ] Block %2: Blank programmed incorrectly
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The alarm is triggered by the following cycles: F_HEAD
The blank has been programmed incorrectly.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Correct the blank.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61297
[Channel %1: ] Block %2: Reference for incremental retraction plane missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The alarm is triggered by the following cycles: F_HEAD
The retraction plane can only be specified in increments if the blank is entered.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
429
Hide quick links:
Advertisement
Table of Contents
