Block %2: Pitch Change Causing; Block %2: Machining Plane Does Not Match Modal; Block %2: Safety Distance Too Small; Block %2: Blank Radius Too Small - Siemens Sinamics S120 Diagnostic Manual

61244 [Channel %1: ] Block %2: Pitch change causing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified pitch change causes a reversal of the thread direction.
Alarm triggered by following cycle: CYCLE99
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check thread pitch change and thread geometry.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61245 [Channel %1: ] Block %2: Machining plane does not match modal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Machining plane does not match modal one.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check the machining plane.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61246 [Channel %1: ] Block %2: Safety distance too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The safety clearance is too small for machining.
Alarm triggered by following cycle: CYCLE79.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Increase safety clearance.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61247 [Channel %1: ] Block %2: Blank radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The blank radius is too small for machining.
Alarm triggered by following cycle: CYCLE79.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Increase blank radius.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
415