[Channel %1:] Contour Tunnel Monitoring; Block %2 Motion-Synchronous Action: Invalid Marker; Traversing Of Command Axis %2 See Nc Alarm %3 Parameter %4 - Siemens Sinamics S120 Diagnostic Manual

NCK alarms
20130 [Channel %1: ] Contour tunnel monitoring
Parameters: %1 = Channel number
Definitions: The tool tip has exited the tunnel placed around the desired contour, i.e. the distance between tool tip and desired
contour was greater than specified in the MD21050 $MC_CONTOUR_TUNNEL_TOL.
The alarm can be reprogrammed in the MD11412 $MN_ALARM_REACTION_CHAN_NOREADY (channel not ready).
Reaction: Mode group not ready.
The NC switches to follow-up mode.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Channel not ready.
Remedy: Please inform the authorized personnel/service department. Check the following points in turn:
1. Is the machine in working order? That is, has the alarm been tripped by a sluggish axis, tool breakage or collision?
2. If the machine is in working order, reduce the velocity or improve the controller setting.
3. Possibly increase the size of the tunnel and monitor errors via analog output in order to ascertain the cause.
Program Teileprogramm neu starten.Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Continuation:
20139 [Channel %1: ] Block %2 motion-synchronous action: invalid marker
Parameters: %1 = Channel number
%2 = Block number
Definitions: Setting or deleting of a marker in the motion-synchronous action is not possible.
Possible causes:
SETM(): Maximum number of markers exceeded; marker has already been set.
CLEARM(): Specified marker is not within permissible value range.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: SETM(): use marker in valid value range; do not set the marker again.
CLEARM(): use marker in valid value range.
Program Clear alarm with the RESET key. Restart part program
Continuation:
20140 [Channel %1: ] Motion synchronous action: traversing of command axis %2 see NC
alarm %3 parameter %4
Parameters: %1 = Channel number
%2 = Axis
%3 = NC alarm
%4 = Additional parameter
Definitions: An NC alarm was detected for a command axis which is to be traversed from a synchronized action. The NC alarm is
indicated by an MMC alarm number in the 3rd parameter. If there is any additional information, this will be provided in
a 4th parameter.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: See help information for the additional alarms.
Program Clear alarm with the RESET key. Restart part program
Continuation:
312
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms