Block %2: Retraction Direction Unknown. Withdraw Tool Manually; Block %2: Machining Direction Unknown; Block %2: Tool Change Point Lies Within Retraction Area; Block %2: %]Wrong Feed Type - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
61237
[Channel %1: ] Block %2: Retraction direction unknown. Withdraw tool manually!
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The tool is in the retraction area and it is unknown in which direction it can be travelled out of it.
Alarm triggered by following cycle: F_SP_RP
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Manually retract the tool from the retraction area defined in the program header and restart the program.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61238
[Channel %1: ] Block %2: Machining direction unknown!
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The direction of the next machining is unknown.
Alarm triggered by following cycle: F_SP_RP.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Please contact the responsible Siemens regional office.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61239
[Channel %1: ] Block %2: Tool change point lies within retraction area!
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The tool change point has to be far enough outside the retraction area so that when the revolver is swiveled, no tool
extends into the retraction area.
The alarm is triggered by the following cycle: F_SP_RP
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Specify another tool change point.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61240
%[[Channel %1: ] Block %2: %]Wrong feed type
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The feed type is not possible for this machining.
Alarm triggered by following cycles: F_DRM_DR, F_DRM_PE, F_DRM_RE, F_DRM_SI, F_GROOV, F_MIM_TR,
F_ROUGH, F_SP_EF, F_UCUT_T, CYCLE952
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
413
Hide quick links:
Advertisement
Table of Contents
