Block %2 Softa Not Available For Axis %3; Block %2 Negative Thread Pitch Change Programmed; Block %2 Negative Value For Maximum Spindle Speed - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Adjust the value range in accordance with the Programming Guide. Values of 1 ... 200% are allowed.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14812
[Channel %1: ] Block %2 SOFTA not available for axis %3
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions:
SOFT is to be set as type of motion control for an axis. This is not possible because a bent acceleration characteristic
has been selected for this axis via machine data.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program or machine data.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14815
[Channel %1: ] Block %2 negative thread pitch change programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
A negative thread pitch change has been programmed.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Correct the value assignment. The programmed F value should be greater than zero. Zero is allowed but has no effect.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14820
[Channel %1: ] Block %2 negative value for maximum spindle speed programmed with
constant cutting speed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
For the function "Constant cutting speed G96" a maximum spindle speed can be programmed with the keyword
LIMS=.... The values are in the range 0.1 - 999 999.9 [rev/min].
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Program the maximum spindle speed for the constant cutting speed within the limits given above. The keyword LIMS
is modal and can either be placed in front of or within the block that selects the constant cutting speed.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
200
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
