Block %2 Orientation Axes And Lead/Tilt Angles Programmed; Block %2 Orientation Axes Incorrectly Configured; Block %2 G Code For Orientation Definition Not Allowed; Block %2 G Code For Orientation Interpolation Not Allowed - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
14131
[Channel %1: ] Block %2 orientation axes and lead/tilt angles programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
An orientation angle and a leading or sideways angle were programmed at the same time.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program
Clear alarm with NC START or RESET key and continue the program.
Continuation:
14132
[Channel %1: ] Block %2 orientation axes incorrectly configured
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Possible causes:
- The configuration of the orientation axes does not match the machine kinematics. Also, for example, when the posi-
tion measuring system has not been set for the rotary axes.
- An axis that is required as orientation axis is currently not available as path axis.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Adapt machine data.
Provide the required orientation axes using GET(..) or GETD(..).
Program
Clear alarm with the RESET key. Restart part program
Continuation:
14133
[Channel %1: ] Block %2 G code for orientation definition not allowed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
It is only possible to program a G code of the 50th G code group if MD21102 $MC_ORI_DEF_WITH_G_CODE is set
to TRUE.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Adapt machine data.
Program
Clear alarm with the RESET key. Restart part program
Continuation:
14134
[Channel %1: ] Block %2 G code for orientation interpolation not allowed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
It will only be possible to program a G code of the 51st G code group, if MD21104 $MC_ORI_IPO_WITH_G_CODE
has been set to TRUE.
164
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
