Block %2: Data Of Tool %3 Cannot Be Deleted; Block %2 Deleting Magazine Data Not Possible; Block %2 Access To Variable Not Possible - Siemens Sinamics S120 Diagnostic Manual

17200 [Channel %1: ] Block %2: Data of tool %3 cannot be deleted.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number
Definitions: An attempt has been made to delete from the part program the tool data for a tool currently being processed. Tool data
for tools involved in the current machining operation may not be deleted. This applies both for the tool preselected with
T or that has been changed in place of another, and also for tools for which the constant grinding wheel peripheral
speed or tool monitoring is active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check access to tool offset memory by means of $TC_DP1[t,d] = 0 or deselect tool.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17202 [Channel %1: ] Block %2 deleting magazine data not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt was made to delete magazine data which cannot currently be deleted. A magazine with the 'tool in motion'
status active cannot be deleted. A tool adapter which is currently allocated to a magazine location cannot be deleted.
A tool adapter cannot be deleted if MD18104 $MN_MM_NUM_TOOL_ADAPTER has the value -1.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: If an attempt to delete a magazine fails
$TC_MAP1[ m ] = 0 ; Delete magazine with m=magazine no.
$TC_MAP1[ 0 ] = 0 ; Delete all magazines
$TC_MAP6[ m ] = 0 ; Delete magazines and all their tools you must ensure that the magazine does not have the 'tool
in motion' status at the time of the call.
If an attempt to delete a tool adapter fails
$TC_ADPTT[ a ] = -1 ; Delete adapter with number a
$TC_ADPTT[ 0 ] = -1 ; Delete all adapters
then the data association with the magazine location or locations must first be canceled with $TC_MPP7[ m,p ] = 0 ;
m = magazine no., p = no. of the location to which the adapter is assigned.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17210 [Channel %1: ] Block %2 access to variable not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The variable cannot be written/read directly from the part program. It is allowed only in motion synchronous actions.
Example for variable:
$P_ACTID (which planes are active)
$AA_DTEPB (axial distance-to-go for reciprocating infeed)
$A_IN (test input)
Safety Integrated: Safety PLC system variables can only be read during the safety SPL setup phase.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
277