Block %2: Angle 1St Edge - 2Nd Edge Equals 0; Block %2: Angle Rel. To Reference Edge Equals 0; Block %2: Tool Length Or Radius Is 0 - Siemens Sinamics S120 Diagnostic Manual
Hide thumbs
Also See for Sinamics S120:
- Function manual (1094 pages) ,
- Manual (848 pages) ,
- Equipment manual (570 pages)
Table of Contents
Advertisement
NCK alarms
61347
[Channel %1: ] Block %2: Angle 1st edge - 2nd edge equals 0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggerd by the following cycles: CYCLE961.
Remedy:
Parameter following angle (_INCA) equals 0.
61348
[Channel %1: ] Block %2: Angle rel. to reference edge equals 0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program
Clear alarm with the RESET key. Restart part program
Continuation:
61349
[Channel %1: ] Block %2: Distance upper probe edge - measuring position = 0 for tool
radius measurement
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggerd by the following cycles: CYCLE971
Remedy:
The distance between the upper and lower edges of the tool probe equals 0; relevant for radius measurement.
For 840D: Check parameter _TP[x,9]
For 840D sl: Check setting data 54634 $SNS_MEA_TP_CAL_MEASURE_DEPTH
61350
[Channel %1: ] Block %2: Feed, speed not programmed for tool measurement with
rotating spindle
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggered by the following cycles: CYCLE971.
The measuring feed and/or spindle speed during tool measurement with rotating spindle is not specified in the GUD
variable _MFS.
Remedy:
Check parameter _MFS[0]
61351
[Channel %1: ] Block %2: Tool length or radius is 0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Definitions:
The alarm is triggerd by the following cycles: CYCLE971
Remedy:
Cutter: - Check length and radius of the active tool in the compensation data memory
Drill: - Check length of the active tool in the compensation data memory
- Radius or tip angle of the active tool must be predefined in the compensation data memory
440
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
Alarms
Hide quick links:
Advertisement
Table of Contents
