Block %2: Machining Not Possible, Check Tool Angle; Block %2: %]No Master Spindle Active; Block %2: Main Spindle Not Set Up; Block %2: Counterspindle Not Set Up - Siemens Sinamics S120 Diagnostic Manual

61286 [Channel %1: ] Block %2: machining not possible, check tool angle.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Machining not possible with the specified tool.
Alarm triggered by following cycles: F_UCUT_T.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a suitable tool.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61287 %[[Channel %1: ] Block %2: %]no master spindle active.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No master spindle active.
Alarm triggered by following cycle: CYCLE63, CYCLE64, F_TFS.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Activate the master spindle (machine data 20090).
Program Clear alarm with the RESET key. Restart part program
Continuation:
61288 [Channel %1: ] Block %2: Main spindle not set up
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE210
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter channel axis number of main spindle in MD52206 $MCS_AXIS_USAGE.
Program Clear alarm with the RESET key. Restart part program
Continuation:
61289 [Channel %1: ] Block %2: Counterspindle not set up
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE210
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter channel axis number of counterspindle in MD52206 $MCS_AXIS_USAGE.
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
427